Deviation Analysis Of Slitting Machine

The cutting machine blade cuts the cardboard with a skewed tail:
1. Improper adjustment of the paper feeding positioning plate of the slitting machine blade; 2. The slitting blade has a section that is too blunt and has a difference in linear speed compared to other blades; 3. Improper adjustment of the paper guide wheel of the slitting machine blade; 4. Improper paper feeding of the slitting machine blades.
Cutting machine blades produce burrs:
1. The cutting machine blade is dull and should be polished; 2. The overlap between the cutting machine blade and the cutting groove is too shallow; 3. The groove of the cutting machine blade is entangled with paper edges and paper fuzz, which should be thoroughly cleaned before starting up; 4. The gap between the slots of the cutting machine blades is too large, and it is generally recommended to not exceed 2.5mm.
The indentation line of the cutting machine blade is prone to breakage:
1. Low quality base paper; 2. The pressure line is too deep.
The indentation line of the cutting machine blade is not straight:
1. The blade of the slitting machine is pressed too shallowly, and the broken lines are uneven, which affects the appearance of the box; 2. The paper feeding of the slitting machine blade is skewed; 3. The upper and lower wire pressing wheels of the slitting machine blade are not aligned.
The cutting edge of the slitting machine blade is not perpendicular:
1. The angle of the cutting machine blade holder is not correct; 2. The cutting machine blade is not in the center of the groove; 3. The cutting blade of the slitting machine is worn off.